Precisely Calibrating The Listening Position - Intelligent Time Alignment Tune; Speaker Configuration And Volume Setup; Creating A Virtual Center Speaker; Cso - Sony XAV-70BT Operating Instructions Manual
Av center
Hide thumbs
Also See for XAV-70BT:
- Operating instructions manual (240 pages) ,
- Installation/connections (2 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Precisely calibrating the listening
position
— Intelligent Time Alignment Tune
You can precisely calibrate your listening
position from each speaker so that the sound
delay reaches the listener more correctly.
Before starting, measure the distance between
your listening position and each speaker.
1
During reception/playback, touch
“Source List,” then
.
2
Touch “Sound,” then “Listening
Position.”
3
Touch “Custom,” then “Custom Tune.”
The setting display appears.
Back
ATT
Top
Position Tune
100
100
100
100
100
(cm)
Reset
OK
15
12:00
4
Touch +/– of each speaker to set the
distance between your listening
position and the speakers.
13
The distance is adjustable in 2 cm (
/
in)
16
1
steps, between 0 and 400 cm (0 and 13
/
ft).
10
To restore the default setting, touch “Reset.”
5
Touch “OK.”
The setting is complete.
To return to the previous display, touch “Back.”
Note
The setting is applied only after “OK” is touched.
46
Speaker configuration and
volume setup
Creating a virtual center speaker
— CSO
To fully enjoy surround sound, it is adequate to
have 5 speakers (front left/right, rear left/right,
center) and 1 subwoofer. CSO (Center Speaker
Organizer) allows you to create a virtual center
speaker even though a real center speaker is not
connected.
1
During disc/USB playback, touch
“Source List,” then
.
2
Touch “Sound.”
The sound setting menu appears.
3
Touch “CSO.”
The options appear.
4
Touch “CSO1,” “CSO2” or “CSO3.”
The setting is complete.
To return to the previous display, touch “Back.”
Note
“CSO” is effective only when “Multi Ch Output” is set to
“Multi” (page 54), as it is effective only for playback of
multi-channel sources.
Using rear speakers as subwoofer
— RBE
RBE (Rear Bass Enhancer) enhances the bass
sound by applying the low pass filter setting
(page 53) to rear speakers. This function allows
rear speakers to work as a subwoofer even if it is
not connected.
1
During reception/playback, touch
“Source List,” then
.
2
Touch “Sound.”
The sound setting menu appears.
3
Touch v/V to scroll, then “RBE.”
The options appear.
4
Touch “RBE1,” “RBE2” or “RBE3.”
The setting is complete.
To return to the previous display, touch “Back.”
- Quick Links:
- Resetting the Unit
Hide quick links:
Advertisement
Table of Contents
