Table of Contents
Advertisement
16 | Installation
▶ The appliance must not be installed in sites where the
ambient temperature is susceptible to drop below 0 °C.
Where there is a risk of freezing, disconnect and empty the
appliance (Fig. 6).
Combustion air
▶ The air admission grill must be located in a well ventilated
area.
▶ To avoid corrosion, products such as solvents, inks,
inflammable gases, glue or domestic detergents containing
halogenic hydro-carbons or any product that might
provoke corrosion must not be stored near the air
admission grill.
Where these conditions are impossible to fulfil, an alternative
site for gas admission and exhaust must be selected.
Surface Temperature
The maximum surface temperature of the appliance is below
85 °C. Special protection measures are not required for
inflammable building materials or housings.
6.3
Minimum distances
Determine the installation site with the following limitations in
mind:
▶ Maximum seclusion of all salient parts such as hoses and
pipes, etc.
▶ Ensure adequate access for maintenance work, respecting
the minimum distances indicated in Fig. 13.
Fig. 13
Minimum distances
[A] Front 2 cm, lateral 1 cm
[B] 40 cm
6 720 607 800 (2016/02)
6.4
Installation of support bar
Before installing the support bar, ensure that
the water/gas/exhaust connections are
guaranteed.
▶ Fix the support bar to the installation point selected.
▶ Mark the position of the fixing holes on the bar and open the
respective holes.
▶ Fix the support bar to the wall.
6.5
Installation
CAUTION: Possibility of damage caused by
foreign bodies!
▶ Purge all tubes to eliminate possible
foreign bodies.
▶ Remove appliance from packaging.
▶ Ensure that all indicated parts are included.
▶ Remove the plugs from the gas and water connections.
▶ Remove the mirror from the appliance by pushing it lightly
towards (Fig. 14, [1]).
▶ Loosen the two screws (Fig. 14, [2]).
Fig. 14
Remove front cover
▶ Pull forward.
▶ Fix the appliance in a vertical position.
Hide quick links:
Advertisement
Table of Contents
