Modifying Engine Settings - Dell DL1000 User Manual

Hide thumbs Also See for DL1000:
Table of Contents

Advertisement

deduplication cache holds references to unique blocks. By default, the deduplication cache is 1.5 GB. If
the amount of redundant information isso large that the deduplication cache is full, your repository can
no longer take full advantage of further deduplication across your repository for newly added data. You
can then increase the size of the deduplication cache by changing the deduplication cache configuration
in the Core Console.
To configure deduplication cache settings:
1.
Navigate to the Core Console, click Configuration → Settings.
2.
In the Deduplication Cache Configuration section, click Change.
The Deduplication Cache Configuration dialog box appears.
3.
In the Primary Cache Location text box, enter the updated primary cache location.
4.
In the Secondary Cache Location text box, enter the updated secondary cache location.
5.
In the Metadata Cache Location text box, enter the updated metadata cache location.
6.
Click OK.
NOTE: You must restart the Core service for the changes to take effect.

Modifying engine settings

To modify engine settings:
1.
Navigate to the Core Console, click Configuration → Settings.
2.
In the Replay Engine Configuration section, click Change.
The Replay Engine Configuration dialog box appears.
3.
In the Replay Engine Configuration dialog box, specify the IP address. Select one of the following:
To use the preferred IP address from your TCP/IP, click Automatically Determined.
To manually enter an IP address, click Use a specific IP Address.
4.
Enter the configuration information described as follows:
Text Box
Preferable Port
Admin Group
Minimum Async
I/O Length
Receive Buffer
Size
Send Buffer Size
Read Timeout
Write Timeout
5.
Select No Delay.
Description
Enter a port number or accept the default setting (8007 is the default port).
The port is used to specify the communication channel for the engine.
Enter a new name for the administration group. The default name is BUILTIN
\Administrators.
Enter a value or choose the default setting. It describes the minimum
asynchronous input/output length. The default setting is 65536.
Enter an inbound buffer size or accept the default setting. The default setting is
8192.
Enter an outbound buffer size or accept the default setting. The default setting
is 8192.
Enter a read timeout value or choose the default setting. The default setting is
00:00:30.
Enter a write timeout value or choose the default setting. The default setting is
00:00:30.
19

Advertisement

Table of Contents
loading

Table of Contents