Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Motorola RSVP
Summary of Contents for Motorola RSVP
- Page 1 THE UNION OF PAGING AND CELLULAR TECHNOLOGIES User’s Guide...
-
Page 2: Using This Guide
RSVP also features a removable and rechargeable, ultra-thin, Nickel-Metal- Hydride cellular battery. RSVP slides onto the back of your phone in place of the existing battery unit, providing the control and convenience of a pager and a phone in a single unit. - Page 3 PROCEDURE FOR CONNECTING YOUR NEW RSVP PAGER TO YOUR CELLULAR PHONE Remove battery from any Motorola MicroTAC or retail pocket personal cellular telephone in the following manner: Press and hold down battery release Lift battery off cellular phone Slide battery...
- Page 4 Note: Ensure the Nickel-Metal-Hydride battery is fully charged and installed in the RSVP pager before performing this procedure. Install your RSVP pager in place of the cellular phone battery in the following manner: Set RSVP onto mounting slide approximately one inch below...
- Page 5 CONTROLS AND DISPLAY INDICATORS The locations and descriptions of the RSVP pager controls and display indicators are shown below: Display On/Read/ Select Button Pager Display: Alarm Indicator 10:47a Alert Mode Time Indicator of Day 12:48p Message Slot Number Alert/Backlight Indicator...
-
Page 6: Reading Messages
The time of day and the “Alert Mode” indicator, silent ( [ ) or audible ( D ), is displayed. READING MESSAGES The RSVP pager can receive up to eight 20-character mes- sages. When a message is received, the pager alerts with an audible or a vibrate alert, and a flashing alert indication. -
Page 7: Setting The Alarm
CHANGING ALERT MODES 1. Press X . Either “Silent?” or “Audio?” is displayed, depending on the current mode. 2 . To change the alert mode, press W . For your pager to vibrate, it must be in the “silent” mode. TURNING YOUR PAGER OFF 1. -
Page 8: Locking And Unlocking Messages
The “ERASE ALL?” prompt is displayed if there are read- unlocked messages in memory. BATTERY FEATURES The RSVP pager features a removable and rechargeable Nickel-Metal-Hydride cellular battery unit. RSVP replaces your cellular phone’s battery and provides charging contacts in an identical location. Your existing cellular charger may be... -
Page 9: Battery Replacement
BATTERY REPLACEMENT Remove RSVP from your cellular telephone and replace the RSVP battery as shown below: Press release then slide pager downward away from antenna Turn pager over, insert tip of ball pen under release and pry up on release, then lift... -
Page 10: Charging Your Battery
Refer to the charger manufacturer’s instructions for specific use of your charger. PROPER CARE The RSVP pager is durable, reliable, and can provide many years of dependable service, but it is a precision electronic product. Water and moisture, excessive heat, and extreme shock may cause damage to the pager. -
Page 11: Repair And Maintenance
CLEANING YOUR RSVP PAGER To clean smudges and grime from the exterior of your RSVP pager as well as your cellular phone, use a soft, non-abrasive cloth moistened in a mild soap and water solution. Rinse the surface using a second cloth moistened in clean water. Do not use alcohol or other cleaning solutions. - Page 12 © Copyright 1995, Motorola, Inc. All Rights Reserved. Motorola Derivative Technologies Division, 3301 Quantum Blvd., Boynton Beach, FL 33426, Printed in U.S.A. 10/95, t , Motorola, MicroTAC, and RSVP are trademarks or registered trademarks of Motorola, Inc. Contents of this manual subject to change without notice...