HP EliteBook 820 G3 Maintenance And Service Manual page 47

4. To remove the hard drive cover and bracket from the hard drive, lift the Mylar cover up off the drive,
remove the 4 Phillips PM3.0×3.0 screws (1) that secure the bracket to the drive, and then lift the bracket
up and off the hard drive (2).
Reverse this procedure to install a hard drive.
NOTE: Only a hard drive or an SSD can be installed. To install a hard drive, be sure that the standee is stored
beside the hard drive slot and not installed across from the SSD connector.
Component replacement procedures 37