Checking that your oven is operating correctly
The following simple procedure enables you to check that your oven is working correctly
at all times. If you are in doubt, refer to the section entitled "Troubleshooting" on the page
The oven must be plugged into an
appropriate wall socket. The turntable must
be in position in the oven. If a power level
other than the maximum (100 % - 850 W) is
used, the water takes longer to boil.
Setting the time
When power is supplied, "88:88" and then "12:00" is automatically displayed on the display.
Please set the current time. The time can be displayed in either the 24-hour or 12-hour
notation. You must set the clock:
When you first install your microwave
After a power failure
Open the oven door by pulling the handle
on the upper side of the door.
Place a glass of water on the turntable.
Close the door
Press the START/+30s button and set the
time to 4 or 5 minutes, by pressing the
START/+30s button the appropriate number
The oven heats the water for 4 or
5 minutes. The water should then
Do not forget to reset the clock when you
switch to and from summer and winter time.
1. Press the Clock button.
2. Turn the Dial to set time display type.
(12H or 24H)
3. Press the Select button to complete the
4. Turn the Dial to set the hour.
6/25/2015 3:44:37 PM