Listening To The Radio - Sony LBT-XGR90AV Operating Instructions Manual

To change the AM tuning interval
(Except for the Middle Eastern
model)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
TUNER ENTER, press ?/1 to turn the system
back on. When you change the interval, all the
AM preset stations will be erased. To reset the
interval, repeat the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for half a day even
if you unplug the power cord or if a power failure
occurs.
• To improve broadcast reception, reorient or move
the supplied antennas near a window or outdoors.

Listening to the radio

You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner's memory first
(see "Presetting radio stations" on page 12).
1
Press TUNER/BAND repeatedly to
select "FM" or "AM."
2
Press TUNING MODE repeatedly until
"PRESET" appears.
3
Press TUNING –/+ repeatedly to select
the desired preset station.
Listening to non-preset radio
station
— Manual Tuning
1
Press TUNER/BAND repeatedly to
select "FM" or "AM."
2
Press TUNING MODE repeatedly until
"MANUAL" appears.
3
Press TUNING –/+ repeatedly to tune in
the desired station.
Tips
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
• When an FM stereo program has static noise, press
FM MODE repeatedly until "MONO" appears.
There will be no stereo effect, but the reception will
improve.
• Press TUNING MODE repeatedly until "AUTO"
appears in step 2 above, then press TUNING –/+.
The frequency indication changes and scanning
stops when the system tunes in a station (Automatic
Tuning).
• To record from the radio, see "Recording to a tape"
on page 15.
GB
13