Ddns Service Settings; Static Ip User - Foscam FI8910W Quick Installation Manual

Hide thumbs Also See for FI8910W:

Table of Contents

router.

Note: If your camera could not connect through WIFI, please see FAQ in user

manual.

5 DDNS Service Settings

Static IP users do not need to set DDNS service settings for remote access.

When finished the connection of camera in LAN and port forwarding(Figure

3.5/3.6)，you can access the camera directly from the Internet by the WAN IP and

port number. There are two ways to obtain your WAN IP.

Obtain the WAN IP from public website

To obtain your WAN IP address, enter the following URL in your browser:

http://www.whatismyip.com.The webpage at this address will show you the

current WAN IP.

Obtain the WAN IP address from the router

You can find the WAN IP from your router. Normally, it is in system status.

For example, here are the steps for the LINKSYS WRT54G router:

Obtain the IP address of the router(LAN gateway address),user name and

password for login the router from the network administrator,

Enter the LAN IP address of the router (LINKSYS WRT54G, default LAN IP

is 192.168.1.1) in the address bar of the IE to login the router; Open the

Status page to find out the WAN address of the router. In this example, the

address is 183.37.28.254.

www.foscam.com

FI8910W Quick Installation Guide

Figure 2.3

- 8 -

Table of Contents