Rj45 Cover - HP ENVY Maintenance And Service Manual

7. Remove the fan.
NOTE:
memory. See steps 2 through 7 for fan removal steps for computer models equipped with a graphics
subsystem with discrete memory.
8. Disconnect the fan cable (1) from the system board.
9. Remove the three Phillips PM2.5×4.4 screws (2) that secure the fan to the top cover.
10. Remove the fan (3).
Reverse this procedure to install the fan.

RJ45 cover

Description
RJ45 cover
Before removing the RJ45 cover, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
Remove the RJ45 cover:
1. Disconnect the battery cable from the system board.
Steps 8 through 10 apply to computer models equipped with a graphics subsystem with UMA
Bottom cover on page 28).
Component replacement procedures
Spare part number
818114-001
49