Panasonic TOUGHBOOK CF-M34 Series Operating Instructions Manual page 10

First-time Operation
5
7
8
2
1
Power
Indicator
Power Switch
10
Slide the battery pack inward until it is firmly in place.
5
CAUTION
Be sure the battery pack is properly connected to the connector.
The cover is closed by inserting the hook at the right end (see illustration) into
6
the groove.
Close the cover using the arrow as a guide.
7
Lock the latch into place.
8
CAUTION
Confirm that the latch lock is correctly in place. Should you decide to carry
your computer without the latch lock in place, the cover may open causing the
6
battery pack to fall out.
5
Connect your computer to a power outlet
CAUTION
Be sure the AC adapter is connected until completing Step 8 on page 11.
Handling the AC adapter
Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
Use only the specified AC adapter with your computer. Using an AC adapter
other than the one supplied might damage the battery and/or the computer.
When the DC plug is not connected to the computer, disconnect the AC cord
from your AC wall outlet.
3
Problems such as sudden voltage drops may arise during periods of thunder and
lightning. Since this could adversely affect your computer, an uninterruptible
power source (UPS) is highly recommended unless the battery pack is installed.
6
Open the display and turn your computer on
Slide the power switch and hold it for approximately one second until the power
indicator ( ) turns on before releasing it.
CAUTION
After confirming that the power indicator has turned on, do not touch the
power switch until Windows setup has started.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
NOTE
The power saving mode ([Power Scheme] in [Control Panel] - [Power Management]) is
factory set, so if there is no input from the keyboard, touch pad, touchscreen or exter-
nal mouse (when one is connected) for a certain interval of time, the power to the LCD
and hard disk is shut down.
The LCD will resume operation when the touch pad or the touchscreen is used, or
a key or an external mouse is pressed.
The power to the LCD may be turned off while Windows is setting up or even when
an application software is being installed. In this case, because it is conceivable that
a selection dialog box will be shown, do not press the Space or Enter key
to attempt to resume from this condition as doing so may trigger a selection, but
instead, press a key unrelated to the direct triggering of a selection, like the
key.
Ctrl
*With Windows 98, "Suspend" is called "Standby".