Printing Does Not Start - Canon pro-10s series Online Manual

Printing Does Not Start

Make sure that the power plug is securely plugged in, then press the ON button
Check1
to turn the printer on.
While the POWER lamp is flashing, the printer is initializing. Wait until the POWER lamp stops flashing and
remains lit.
Note
• When printing large data such as a photo or graphics, it may take longer to start printing. While the
POWER lamp is flashing, the computer is processing data and sending it to the printer. Wait until printing
starts.
Make sure that the printer is connected to your computer properly.
Check2
When the printer is connected to your computer with a USB cable, make sure that the USB cable is securely
plugged in to the printer and the computer, then check the followings:
• If you are using a relay device such as a USB hub, disconnect it, connect the printer directly to the
computer, and try printing again. If printing starts normally, there is a problem with the relay device. Consult
the reseller of the relay device for details.
• There could also be a problem with the USB cable. Replace the USB cable and try printing again.
When you use the printer over LAN, make sure that the printer is connected to the network with a LAN cable or
is set up correctly.
If you are printing from the computer and there are any unnecessary print jobs,
Check3
delete them.
Deleting the Undesired Print Job
Make sure that the disc tray guide is closed.
Check4
If the disc tray guide is opened, close the disc tray guide and press the RESUME/CANCEL button on the printer.
Is the manual feed tray in the paper feed position?
Check5
If the manual feed tray is in the paper jam clearing position, return the tray to the paper feed position and press
the RESUME/CANCEL button on the printer.
Is the feed slot cover closed?
Check6
If the feed slot cover is opened, close it slowly and press the RESUME/CANCEL button.
Does the page size setting match the size of the paper loaded in the printer?
Check7
Press the RESUME/CANCEL button on the printer to clear the error. Then check the Paper Size setting in the
Page Setup dialog and load paper that is the same size as the setting and try printing again.
360