Unregistering Thermostat; Disconnecting Wi-Fi - Honeywell RTH6500 User Manual

Unregistering thermostat

If you remove the thermostat from your
Total Connect Comfort website account
(for example, you're moving and leaving
the thermostat behind), the thermostat will
display Register at Total Connect until it is
re-registered.
M33876

Disconnecting Wi-Fi

Replacing your router
If you disconnect the thermostat from your Wi-Fi
network:
1 Enter system setup (see page 18).
2 Change setting 39 to 0 (see page 19).
M33855
The screen will display Wi-Fi Setup.
Re-connect to a Wi-Fi network by following the steps on page 10.
Turning Wi-Fi off
If you do not plan to control the thermostat remotely, you can remove the Wi-Fi Setup
message from the screen:
1 Enter system setup (see page 18).
2 Change setting 38 to 0 (see page 19). Wi-Fi Setup will be removed from the screen.
If you want to connect to the Wi-Fi network later, change setting 38 back to 1.
Software updates
Honeywell periodically issues updates to the software for
this thermostat. The updates occur automatically through
your Wi-Fi connection. All your settings are saved, so
you will not need to make any changes after the update
occurs.
While the update is taking place, your thermostat screen
M34001
flashes Updating and shows the percentage of the update
that has occurred. When the update is complete, your
home screen will appear as usual.
Percentage of
Note:
If you are not connected to Wi-Fi, you will not get
update complete
automatic updates.
16
69-2715EF—07