Table of Contents
Advertisement
Additional Information
Troubleshooting
If you experience any of the following
difficulties while using the player, use this
troubleshooting guide to help remedy the
problem before requesting repairs. Should
any problem persist, consult your nearest
Sony dealer.
Power
The power is not turned on.
, Check that the mains lead is connected
securely.
Picture
There is no picture/picture noise appears.
, Re-connect the connecting cord securely.
, The connecting cords are damaged.
, Check the connection to your TV (page 16)
and switch the input selector on your TV so
that the signal from the player appears on
the TV screen.
, The disc is dirty or flawed.
, If the picture output from your player goes
through your VCR to get to your TV or if
you are connected to a combination TV/
VIDEO player, the copy-protection signal
applied to some DVD programmes could
affect picture quality. If you still experience
problems even when you connect your
player directly to your TV, try connecting
your player to your TV's S VIDEO input
(page 16).
, You have selected "PROGRESSIVE
AUTO" or "PROGRESSIVE VIDEO"
using the PROGRESSIVE button on the
front panel (the PROGRESSIVE indicator
lights up) even though your TV cannot
accept the progressive signal. In this case,
disconnect the HDMI cord from the player
and then select "NORMAL
(INTERLACE)" so that the
PROGRESSIVE indicator turns off.
, Even if your TV is compatible with
progressive format 525p/625p signals, the
image may be affected when you set the
player to progressive format. In this case,
select "NORMAL (INTERLACE)" using
the PROGRESSIVE button on the front
82
panel so that the PROGRESSIVE indicator
turns off and the player is set to normal
(interlace) format.
, The VIDEO OFF function takes effect.
, The player is connected to an input device
that is not HDCP compliant (the HDMI
indicator on the front panel does not light
up). See page 17.
, If the HDMI OUT jack is used for video
output, changing the "HDMI
RESOLUTION" setting in "SCREEN
SETUP" may solve the problem (page 73).
Connect the TV and the player using a video
jack other than the HDMI OUT, and switch
the TV's input to the connected video input
so that you can see the on-screen displays.
Change the "HDMI RESOLUTION"
setting in "SCREEN SETUP," and switch
the TV's input back to HDMI. If the picture
still does not appear, repeat the steps and try
other options.
, If the signal from the LINE OUT (VIDEO)
or S VIDEO OUT jacks is distorted, change
the "HDMI RESOLUTION" setting in
"SCREEN SETUP" to "720 × 480/576p."
There is no picture or the picture noise
appears when connected to the HDMI OUT
jack.
, Try the following: 1Turn the player off
and on again. 2Turn the connected
equipment off and on again. 3Disconnect
and then connect the HDMI cord again.
The picture does not fill the screen, even
though the aspect ratio is set in "TV TYPE"
under "SCREEN SETUP."
, The aspect ratio of the disc is fixed on your
DVD.
Sound
There is no sound.
, Re-connect the connecting cord securely.
, The connecting cord is damaged.
, The player is connected to the wrong input
jack on the amplifier (receiver) (page 20).
, The amplifier (receiver) input is not
correctly set.
, The player is in pause mode or in Slow-
motion Play mode.
, The player is in fast forward or fast reverse
mode.
, If the audio signal does not come through
the DIGITAL OUT (OPTICAL or
Advertisement
Table of Contents
