Default Settings; Setting Operational Modes; Normal Mode - Zip 203362 Clage- Hydroboil Installation And Operating Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

In 2 Hour Sleep Mode, if there has been no water drawn through the tap or no touches of the capacitive switch sensors

for two hours, the temperature of the water in the tank will be allowed to drop to and be maintained at 65ºC. (The time

taken for the water temperature to drop to 65ºC can be as much as 12 hours depending on ambient conditions and other

external factors).

In 4 Hour Sleep Mode, if there has been no water drawn through the tap or no touches of the capacitive switch sensors

for four hours, the temperature of the water in the tank will be allowed to drop to and be maintained at 65ºC.

As soon as water is drawn through the tap, or there is a touch on the capacitive switch sensors, the Hydroboil returns to

full power mode.

In Low Light Mode, as soon as the ambient light (in the room where the Hydroboil is installed ) drops below 100lux, the

unit goes into energy saver mode and will allow the temperature of the stored water to drop to and be maintained at

65ºC. As soon as the ambient light rises above 100lux, the Hydroboil returns to full power mode.

A normal office has an ambient light level of 200-300lux.

The Default configuration for the Hydroboil is as follows.

TEMPERATURE SETPOINT:

FILTER TIMER:

SLEEP MODE:

LOW LIGHT MODE:

SUN ON TIME 1:

--:--

SUN OFF TIME 1: --:--

SUN ON TIME 2:

--:--

SUN OFF TIME 2: --:--

MON ON TIME 1: 08:00

MON OFF TIME 1: --:--

MON ON TIME 2: --:--

MON OFF TIME 2: --:--

TUE ON TIME 1:

--:--

TUE OFF TIME 1: --:--

TUE ON TIME 2:

--:--

TUE OFF TIME 2: --:--

Normal display

Clage-Zip Hydroboil Electronic - Installation & Operating Instructions - 87490 - June 2009