Troubleshooting - Electrolux ESF 6800ROW User Manual

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
An intermittent acoustic signal operates.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
Display
Attention: no intake of water possible.
Attention: water is not draining.
Attention: The anti flood system has
been activated.
WARNING!
Deactivate the appliance before
you do the check.
Problem
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
The appliance does not drain the
water.
The anti-flood device is on.
When the check is completed, activate
the appliance. The programme continues
from the point of interruption.
With some problems, the display
shows a message.
Problem
The appliance does not fill with water.
The appliance does not drain the wa-
ter.
The anti-flood device is on.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse in
the fuse box.
Make sure that the appliance door is closed.
Press OK .
If the delay start is set, cancel the setting or
wait for the end of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water sup-
ply is not too low. For this information, con-
tact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not
clogged.
Make sure that the inlet hose has no kinks or
bends.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or
bends.
Close the water tap and contact the Service.
If the problem occurs again, contact the
Service.
If the display shows other messages, con-
tact the Service.
ENGLISH 35