Dph-70E Configuration - D-Link DPH-70E User Manual

7 DPH-70E Configuration

DPH-70E voice menu helps you through the configuration process. You can enter the
configuration menu by pressing the Menu key when DPH-70E is in idle state.
DPH-70E will ask for password on entering configuration menu. Since the configuration
information contains valuable information it is password protected. If you don't remember your
password, you can reset DPH-70E to default password as described in Loading factory defaults.
The default password is '12345'.
Warning:
DPH-70E identifies end of a parameter by ENTER. Please terminate each parameter
entry into DPH-70E by pressing ENTER key.
DPH-70E configuration menu is shown below. Each of the different options in the menu are
described below. The configurable parameters are shown in bold letters. DPH-70E plays the
current value of each parameter and allows you to edit or skip to next parameter. After entering a
parameters value, it plays it back for verification.
After password verification, DPH-70E will play the main menu as below.
"Press
'1' to enter ISP parameters,
'2' to enter calling card parameters,
'3' to enter Phone Settings
'4' to enter Advanced Settings
'5' to review configuration parameters,
'6' to save & quit
Note:
If power goes off while you are configuring, the phone will work with the previous saved
parameters.
If you idle more than 90 seconds, DPH-70E will accept the keys entered and go to next
state.
If you leave the phone without completing the configuration it will go back to idle state
without saving the parameters.
DPH-70E User's Guide
17