Installing The Shelf Supports; Cleaning The Oven Door; Removing The Door - AEG 68456VS-MN User Manual

30 www.aeg.com

Installing the shelf supports

Install the shelf supports in the opposite
sequence.
Valid with telescopic runners:
The retaining pins on the tele-
scopic shelf runners must point
to the front!
CAUTION!
Make sure that the longer fixing
wire is in the front. The ends of
the two wires must point to the
rear. Incorrect installation can
cause damage to the enamel.

11.3 Cleaning the oven door

To make the cleaning easier, remove the
door.

Removing the door:

1
When the cleaning procedure is comple-
ted, insert the oven door in the opposite
sequence. Make sure that you hear a
click when you insert the door. Use force
if necessary.
2
1
2
2. Pull the rear end of the shelf sup-
port away from the side wall and re-
move it.
WARNING!
Make sure that the glass panels
are cool before you clean the
glass door. There is a risk that
the glass could break.
WARNING!
When the door glass panels are
damaged or have scratches, the
glass becomes weak and can
break. To prevent this, you must
replace them. For more instruc-
tions, contact your local Service
Centre.
1. Open the door fully.
2.
Move the slider until you hear a click.
3. Close the door until the slider locks.
4. Remove the door.
To remove the door, pull the
door outwards first from one
side, and then the other.
11.4 Oven glass panels
The door glass on your product
can be different in type and
shape from the examples you
see in the diagrams. The number
of glasses can also be different.