Table of Contents
Advertisement
QQ
3 7 63 1515 0
[COLD RESET]
• The cold reset clears all data including preset data stored in the
RAM to initial conditions. Execute this mode when returning
the set to the customer.
Procedure:
1. Press
button,
x
simultaneously.
2. The fluorescent indicator tube becomes blank for a while, and
the set is reset.
[VACS ON/OFF]
• This mode is used to switch ON and OFF the VACS (Variable
Attenuation Control System).
Procedure:
1. Press
button to turn the set ON.
?/1
[AMP MENU]
2.
Press
simultaneously. The message "VACS OFF" or "VACS ON"
appears.
[TUNER STEP CHANGE]
• The step interval of AM channels can be toggled between 9 kHz
and 10 kHz.
Procedure:
1. Press
button to turn the set ON.
?/1
[TUNER/BAND]
2. Press
3. Press
button to turn the set OFF.
?/1
TE
L 13942296513
[AMP MENU]
4. Press
The system will turn ON automatically. The message "AM 9k
STEP" or AM 10k STEP" appears and thus the channel step is
changed.
[CD SERVICE MODE]
• This mode let you move the CD sled motor freely. Use this mode
when you want to clean the optical pick-up.
Procedure:
1. Presd
button to turn the set ON.
?/1
2.
Select CD function.
[AMP MENU]
3. Press
,
x
simultaneously.
4. The CD service mode is activated. The message "SERVICE
MODE" appears.
5. With the CD in stop status, press
optical pick-up to outside track, or press
to inside track. The message "SLED OUT" or "SLED IN"
appears.
6. To release this mode, press
www
.
http://www.xiaoyu163.com
[AMP MENU]
button, and
?/1
[GAME MIXING]
button and
button to select the "AM".
button and
button simultaneously.
?/1
Z
button, and
OPEN/CLOSE
button to move the
M
button to move
m
button.
?/1
x
ao
y
i
http://www.xiaoyu163.com
8
[AGING MODE]
This mode can be used for operation check of CD section.
• If an error occurs, the aging operation would stops and the status
is displayed.
• If there are no error occurs, the aging operation would continues
repeatedly.
button
Procedure:
1.
Press
?/1
2. Select CD function.
3. Load three discs on the disc tray.
[PLAY MODE]
4. Press
and press the
5. Press
x
button,
CHANGE]
6. Aging operation is started.
7. To release this mode, press
button
power cord to turn the power OFF.
Aging mode sequence:
Q Q
3
6 7
1 3
Play first track for 2 seconds
Play last track for 2 seconds
EX-CHANGE open/close
button
u163
.
HCD-GN700/GX8800
2 9
9 4
2 8
button to turn the set ON
button to select the "ALL DISCS" mode,
[REPEAT]
button to select "REPEAT OFF" mode.
[AMP MENU]
button, and
button simultaneously.
button or disconnect the
?/1
Start (from disc 1)
Disc chucking
TOC reading
1 5
0 5
8
2 9
9 4
Open the disc tray
Disc skip
Close the disk tray
Change the next disc.
m
co
9 9
[DISC SKIP/ EX-
2 8
9 9
17
Advertisement
Table of Contents
