Burst of Steam
Use for ironing in the vertical and horizontal position. Press the Burst of
Steam button to generate a burst of steam. For best performance, leave
several seconds between bursts.
Press the Spring Mist button to generate a spray of water. Spray Mist is used
to dampen tough wrinkles while dry or steam ironing. Do not spray silk.
3-way Auto Shut Off
The iron will automatically shut off after 30 seconds of inactivity if left on
its soleplate or side. If left vertically on the heel rest, it will shut off after 8
minutes. When the iron is in Auto-Shut Off, the red light on the handle will
blink. Simply move the iron to take it off stand-by.
IRO NI N G T I PS A N D TR IC KS
The iron can be filled with ordinary tap water; if your water is hard, you
may want to use distilled water.
For optimum performance, allow the iron to stand on the heel rest
about two minutes after filling before beginning to iron.
If you're unsure of the fabric's content, test a small area (on the inside
seam or hem) before you proceed to iron the entire garment or cloth.
Whenever ironing a garment with mixed fabrics, select the fabric
setting for the most delicate fabric. For example, when ironing a shirt
that is 65% cotton and 35% polyester, use the "blends" setting
Whenever temperature settings are changed to a higher or lower
temperature, allow the iron to stand a minute or so to allow heat up or
cool down. Test garment by pressing a small hidden area to make sure
temperature of iron is correct.