Sony WX-C5000 Operating Instructions Manual page 21

CD/MD playback
Problem
A disc cannot be loaded.
Playback does not begin.
A disc is automatically ejected.
The operation buttons do not
function.
The sound skips due to
vibration.
The sound skips.
Tape playback
Problem
A cassette cannot be inserted.
During playback, the aerial is
extended.
Playback sound is distorted.
Playback sound is not clear.
The AMS does not operate
correctly.
Playback starts from a blank
space.
Cause/Solution
•Another CD is already loaded.
•The CD is forcibly inserted upside down or in the wrong way
(MD).
Defective MD or dusty CD.
The ambient temperature exceeds 50°C.
Press the reset button.
•The unit is installed at an angle of more than 20°.
•The unit is not installed in a sturdy part of the car.
Dirty or defective disc.
Cause/Solution
Insert a cassette correctly.
If "ATA" appears in the display, the aerial is automatically
extended to receive radio signals while fast-forwarding or
rewinding a tape.
The tape head is contaminated.
t Clean the head with a commercially available dry-type
cleaning cassette.
A tape recorded with Dolby NR off is played back with Dolby
NR on.
t Press (3) (SHUF/;) to set the Dolby NR off (page 11).
•There is noise in the space between tracks.
•A blank space is too short (less than four seconds).
•> on (SEEK/AMS) is pressed immediately before the
following track.
•. on (SEEK/AMS) is pressed immediately after the track
starts.
•A long pause, or a passage of low frequencies or very low
sound level is treated as a blank space.
A tape recorded with Dolby NR on is played back with Dolby
NR off.
t Press (3) (SHUF/;) to set the Dolby NR on (page 11).
continue to next page t
21