Motorola DCH100 User Manual page 5

During Installation
Do not place the cable terminal in an enclosed area where the
cooling vents are blocked or impede the flow of air through the
ventilation openings.
Install the terminal so that its position does not interfere with its
proper ventilation. For example, do not place the terminal on a bed,
sofa, rug, or similar surface that could block the ventilation
openings.
Install the terminal away from heat sources such as radiators, heat
registers and stoves. Installation of the terminal near consumer
electronics devices, such as stereo receiver/amplifiers and
televisions, is permitted as long as the air surrounding the terminal
does not exceed 40 ºC (104 ºF).
Place the terminal on a flat surface not prone to vibration or impact.
Do not install the terminal in an area where condensation occurs.
To prevent the temporary loss of guide data and cause a
temporarily non-responding terminal, do not plug the AC power
cord into a switched power outlet.
FCC COMPLIANCE
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
iii