Sony HD-FLX9W Service Manual page 2

HCD-FLX9W
QQ
3 7 63 1515 0
Signal-to-noise ratio More than 90 dB
Dynamic range More than 90 dB
Video color system format
NTSC, PAL
OPTICAL DIGITAL OUT (Square optical connector
jack, rear panel)
wavelength 660 nm
Tape player section
Recording system 4-track 2-channel stereo
50 − 13,000 Hz (±3 dB),
Frequency response
using Sony TYPE I
cassette
Tuner section
FM stereo, FM/AM superheterodyne tuner
FM tuner section
87.5 − 108.0 MHz
Tuning range
(50-kHz step)
Antenna FM lead antenna
Antenna terminals 75 ohm unbalanced
Intermediate frequency 10.7 MHz
AM tuner section
Tuning range
531 − 1,602 kHz
Saudi Arabian model:
(with the tuning interval
set at 9 kHz)
530 − 1,710 kHz
Other models:
(with the tuning interval
set at 10 kHz)
531 − 1,602 kHz
(with the tuning interval
set at 9 kHz)
Antenna AM loop antenna
TE
L 13942296513
Antenna terminals External antenna terminal
Intermediate frequency 450 kHz
General
Power requirements
120 − 127 V, 220 V or
Saudi Arabian model:
230 − 240 V AC,
50/60 Hz
Adjustable with voltage
selector
Thailand model: 220 V AC, 50/60 Hz
Other models: 120 V, 220 V or
230 − 240 V AC,
50/60 Hz
Adjustable with voltage
selector
425 watts
Power consumption
Approx. 235 × 435 ×
Dimensions (w/h/d)
420 mm
Mass Approx. 15.2 kg
Design and specifications are subject to change
without notice.
www
.
2
http://www.xiaoyu163.com
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
This appliance is classified as
a CLASS 1 LASER product.
The CLASS 1 LASER
PRODUCT MARKING is
located on the rear exterior.
Q Q
3 6 7 1 3 1 5
co
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
.
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
9 4 2 8
0 5 8 2 9 9 4 2 8
m
9 9
9 9