Table of Contents
Advertisement
SIMPLE THERMOSTAT MODE
Simple Mode has the following basic features:
Temperature Control Modes:
Fan Operation Modes:
> TOTALTOUCH™ CAN ALSO FUNCTION AS A NON-PROGRAMMABLE
THERMOSTAT AFTER IT HAS BEEN CONFIGURED.
•
To enable "Simple Mode", press the reset button (take off the thermostat face-
plate and press the reset button located in the bottom right-hand corner). The
message "Touch for simple thermostat" will appear. Touch the screen, and
TotalTouch™ becomes a simplified non-programmable thermostat.
•
Please note that when changing to Simple Mode, you will not lose any of the
settings you have previously entered in the "Programmable Mode".
•
To revert back to the Programmable TotalTouch™ Thermostat, simply press
the reset button and touch the screen when the message "Touch for
Programmable Thermostat" appears.
50
TROUBLESHOOTING
•
Touch screen buttons do not function properly.
ton located in the bottom left corner then accurately touch 3 target centers on the
screen when prompted.
•
Air Conditioning does not turn on even when room temperature is higher then the
temperature set point set point (Humidity models only).
ON and dehumidify set point has been reached. This will cause air conditioning to
turn off. Lower Setpoint – Page 26, Dh CONTROLCOMP – Page 45.
•
Air conditioning turns on in HEAT mode and heating turns on in COOL mode.
the OB valve (see "Advanced Settings" Page 42).
•
PARTIAL LOCK and FULL LOCK do not function.
for 1 minute for TotalTouch™ to automatically lock.
•
Thermostat appears normal until the screen becomes blank when the compressor
or heating system turns on.
You need to connect the "C" wire. 4 wire system will
not function unless the heat and compressor contactors can supply enough cur-
rent to power the thermostat with only 4 wires, if you cannot hook up the "C" wire
another possible solution is to connect one 250 ohm 10 watt resistor in the HVAC
room, for cooling problems between C and W or in the case of heating problem
between C and Y1.
•
I forgot my PIN and cannot unlock the thermostat.
the reset button located in the bottom right corner, as soon as the message "touch
to reset password" appears touch the screen, your PIN will be erased and the ther-
mostat will unlock.
51
Remove cover, press the reset but-
DHCONTROLCOMP is turned
Reverse
You must not touch the screen
Remove the cover plate, press
Hide quick links:
Advertisement
Table of Contents
