Led Definitions; Scanning - Motorola Symbol LS1203 Product Reference Manual

Beeper Definitions (Continued)
Table 2-1
Beeper Sequence
Host Specific
USB only
4 short high beeps
Scanner gives a power-up beep after
scanning a USB Device Type.
This power-up beep occurs more than once.
RS-232 only
1 short high beep

LED Definitions

In addition to beeper sequences, the scanner communicates with the user using a two-color LED display. Table 2-2
defines LED colors that display during scanning.
Standard LED Definitions
Table 2-2
LED
Off
Green
Red

Scanning

The scanner can operate in two scanning modes: triggered mode and Auto-Scan
trigger button must be pressed to emit the scanner laser in order to a scan bar code. In Auto-Scan
scanner laser is in constant on state and no trigger button press is required to scan a bar code.
To toggle between scanning modes, scan Triggered/Auto-Scan
•
If the scanner is in triggered mode, scan Triggered/Auto-Scan
mode.
•
If the scanner is in Auto-Scan
mode.
NOTE When the scanner is not used for an extended period of time in
mode. To wake the scanner, press the trigger button.
Scanner has not completed initialization. Wait several
seconds and scan again.
Communication with the bus must be established before the
scanner can operate at the highest power level.
The USB bus may put the scanner in a state where power to
the scanner is cycled on and off more than once. This is
normal and usually happens when the host cold boots.
A <BEL> character is received and Beep on <BEL> is
enabled.
No power is applied to the scanner, or the scanner is on and ready to scan.
A bar code was successfully decoded.
A data transmission error or scanner malfunction occurred.
TM
mode, scan Triggered/Auto-Scan
Indication
Indication
TM
mode. In triggered mode the
TM
on page 4-5.
TM
on page 4-5 to switch to Auto-Scan
TM
on page 4-5 to switch to triggered
TM
Auto-Scan
mode, it enters sleep
Scanning 2 - 3
TM mode the
TM