Configuring The Scanner - Motorola Symbol LS1203 Product Reference Manual

Mount Stand (Optional)
Attach the base of the scanner stand to a flat surface using two screws or double-sided tape.
NOTE Screws and double-sided tape are not provided.
Two screw-mount holes
Scanner Mount Stand
Figure 1-5
Screw Mount
Position the assembled base on a flat surface.
1.
Screw one #10 wood screw into each screw-mount hole until the base of the stand is secure.
2.
Tape Mount
Peel the paper liner off one side of each piece of tape and place the sticky surface over each of the three
1.
rectangular tape holders.
Peel the paper liner off the exposed sides of each piece of tape and press the stand on a flat surface until it is
2.
secure.

Configuring the Scanner

To configure the scanner, use the bar codes included in this manual, or the 123Scan configuration program.
See Chapter 4, User Preferences
using bar code menus. Also see each host-specific chapter to set up a connection to a specific host type.
See Chapter 9, 123Scan
program.
Rectangular tape holders (3 places)
(dimensions = 1" x 2")
and Chapter 8, Symbologies
to configure the scanner using this configuration program. A help file is available in the
for information about programming the scanner
Getting Started 1 - 5