Switch Action - Makita 3600BR Instruction Manual

By turning the knob, the upper limit of the
tool body can be adjusted. When the tip of
the bit retracted more than required in re ­
lation to the base plate surface, turn the
knob to lower the upper limit.
CAUTION:
• Do not lower the knob too low or the bit will protrude dangerously.
• Before operating the tool, check to be sure that the tool body automatically rises to the
upper limit.
• Do not exceed the upper limit marking on the column when raising the tool body.
• Since excessive cutting may cause overload of the motor or difficulty in controlling the
tool, the depth of cut should not be more than 15 mm (5/8") at a pass when cutting
grooves. When you wish to cut grooves more than 15 mm (5/8") deep, make several
passes with progressively deeper bit settings.
Switch action
To start the tool, move the switch lever
to the "ON" position. To stop, move the
switch lever to the "OF F" position.
Switch lever
II
I
:1
6