Computer Setup-Security - HP Compaq Pro 6305 Maintenance And Service Manual

Computer Setup—Security
NOTE:
Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 3-4
Option
Setup Password
Power-On
Password
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Smart Cover
16 Chapter 3 Computer Setup (F10) Utility
Computer Setup—Security
Description
Allows you to set and enable a setup (administrator) password.
NOTE:
If the setup password is set, it is required to change Computer Setup options, flash the
ROM, and make changes to certain plug and play settings under Windows.
Allows you to set and enable a power-on password. The power-on password prompt appears after
a power cycle or reboot. If the user does not enter the correct power-on password, the unit will not
boot.
Allows you to enable/disable:
Lock Legacy Resources (determines whether or not Windows Device Manager is allowed to
●
change resource settings for serial and parallel ports).
Stringent security (enabling the stringent password disables the ability to reset the password by
●
moving the jumper on the system board). Default is disabled.
CAUTION:
the power-on password, the computer is inaccessible and can no longer be used.
If you lose or forget the password, the system board must be replaced. This scenario is not
covered under warranty.
To prevent the computer from becoming permanently unusable, record your configured setup
password or power-on password in a safe place away from your computer. Without these
passwords, the computer cannot be unlocked.
Setup Browse Mode (appears if a setup password is set) (allows viewing, but not changing,
●
the F10 Setup Options without entering setup password). Default is enabled.
Password prompt on F9 & F12 (requires setup password to use these boot functions). Default is
●
enabled.
Network Server Mode. Default is disabled.
●
Allows you to:
Lock/unlock the Cover Lock.
●
Set the Cover Removal Sensor to Disable/Notify User/Setup Password.
●
NOTE:
Notify User alerts the user that the sensor has detected that the cover has been removed.
Setup Password requires that the setup password be entered to boot the computer if the sensor
detects that the cover has been removed.
If you enable the stringent security feature and you forget the setup password or