Sony SAL50M28 Service Manual page 35

Lens for dslr camera

Hide thumbs Also See for SAL50M28:

Table of Contents

HELP37

Adhesive bond (B-40): J-6082-614-A

Attach the first cam ring linkage plate block to the first cam ring, and apply the adhesive bond (B-40) to the two screws and tighten

them as shown in the figure.

Note: Attach the pin of the first cam ring linkage plate block to the wide chamfered edge side of the first cam ring.

Install the first cam ring so that the post of the first cam ring linkage plate block fits into groove A of the inner barrel. Then install it

with the first cam ring adjust washer.

Aperture Inner Barrel

First Cam Ring

Adjust Washer

1st Cam Ring Hold Ring

HELP38

Adhesive bond (B-40): J-6082-614-A

Attach the front lens barrel, and apply the adhesive bond (B-40) to the three screws and tighten them as shown in the figure.

SAL50M28 (MACRO 2.8/50) (50mm F2.8 Macro)

Groove A

First Cam Ring Linkage

Plate Block

Front Lens Barrel

Apply the

adhesive

bond (B-40)

Apply the

adhesive bond (B-40)

Chamfered edge

(Narrow)

Inner Barrel

Chamfered edge (Wide)

First Cam Ring

Groove A

HELP

Table of Contents

Show Quick Links

Table of Contents