Driven Coupling Removal And Installation; Intermediate Drive Shaft Removal; Bearing Removal - Yamaha waverunner xlt800 Service Manual

JET
PUMP
BEARING HOUSING
1
SERVICE POINTS

Driven coupling removal and installation

1. Remove and install:
Driven coupling
G
Coupler wrench:
YW-06551/90890-06551
Shaft holder:
YB-06552/90890-06552
NOTE:
Install the driven coupling with the same
special tools that were used for removal.

Intermediate drive shaft removal

1. Remove:
Intermediate drive shaft
G
Removal steps:
Temporarily install the driven coupling
G
to the intermediate drive shaft.
Insert the long rod to the driven cou-
G
pling shaft.
G Press out the intermediate drive shaft
by pushing the rod.
NOTE:
Support the intermediate housing with
steel blocks 1 and press the driven cou-
pling shaft.

Bearing removal

1. Remove:
Bearing
G
Driver rod:
YB-06071/90890-06606
Bearing outer race attachment:
YB-06156/90890-06626
NOTE:
Install the bearing with the same special
G
tools that were used for removal.
Support the intermediate housing with
G
steel blocks 1 and press the bearing.
6-23
E