•
rw — Specifies read-write access
•
su — Specifies SNMP administrator access
•
ipv4-address
— Management station IPv4 address. Default is all IP addresses.
Parameters range
community
•
— 1 - 20 chars
ip-address
•
— Valid IP address
Default
No community is defined
Command Mode
Global configuration
Usage Guidelines
The logical key of the command is the pair (community, ip-address). If ip-address is omitted then the key
is (community, All-Ips).
Examples
Switch(conf)# snmp-server community public
Command: username
To establish a username-based authentication system, use the username command in global
configuration mode. Use the no form to remove a user name.
username name [password
name
no username
Syntax Description
name
•
— The name of the user.
•
password
— The authentication password for the user.
•
level
— Specifies the user level. If not specified the privilege level is 1.
•
encrypted — Encrypted password you enter, copied from another device configuration.
Parameters range
name
•
— 1 - 20 characters.
password
•
— 1 - 159
•
level
— 1 - 15
password
level
] [level
] [encrypted]
Dell PowerConnect 28xx Systems User Guide
167