Download Print this page
Morphy Richards 29003 Operating Instructions

Morphy Richards 29003 Operating Instructions

Stereo cd alarm clock radio

Advertisement

Quick Links

Stereo cd alarm
clock radio
29003

OPERATING INSTRUCTIONS

Electrical requirements
Check the voltage on the rating plate of your clock radio corresponds with
your house electricity supply which must be A.C. (Alternating current).
For cd clock radios with a fitted plug.
If the socket outlets in your home are not suitable for the plug supplied with
this appliance the plug should be removed and the appropriate one fitted.
IMPORTANT : THE PLUG REMOVED FROM THE MAINS LEAD, IF SEVERED,
MUST BE DESTROYED AS A PLUG WITH A BARED FLEXIBLE CORD IS
HAZARDOUS IF ENGAGED INTO A LIVE SOCKET OUTLET.
Should the fuse in the 13 amp plug require changing a 3 amp BS1362 fuse
must be fitted.
Battery back-up facility
(unit will work without a battery being fitted)
Your cd alarm clock radio is equipped with a battery back-up facility.
1
Remove the battery compartment cover (at the rear of the unit) by
pushing in the clip and lifting off.
2
Insert a battery size 9 volts PP3/6LR61 (Ensure battery is inserted correctly)
3
Replace the battery compartment cover.
Should a power interruption occur the clock will continue to run, however, time
keeping will not be accurate. The display will be extinguished to conserve battery
life but the memory will retain details of the clock time and alarm settings.
If the optional battery is not installed in case of the AC power failure the display
will blink to indicate the power was interrupted. You will need to reset the clock
and alarm.
Battery back-up is designed to operate for a short period only.
If the unit is not to be used for a prolonged period, remove the battery to
avoid battery leakage.
In the interests of environmental safety : dispose of batteries safely.
P.3
Illustration
27
26
1 2 3
18
15
16
17
Location of controls
1
Play/pause button: to switch unit on and start playback. To
momentarily stopplayback
2
Stop button: to stop cd playback
3
Skip/fast search/selection (
backward /
-to skip cd tracks and for fast search within a track
-for quick and normal setting of alarm clock functions
(quick selection: Press and hold / normal selection: press
repeatedly)
4
PLAY MODE: to play a cd in mixed (random) mode or select
program
5
REPEAT: For continuous cd playback
6
Repeat mode light indicator
7
Play mode light indicator
8
Snooze button: To cancel alarm for 6 minutes
9
Sleep button: to play music automatically, turn off after set
period of time
10
Time button: to set time
1 1
Alarm 2 button: to set alarm 2
12
Alarm 1 button: to set alarm 1
13
Power on/off button: to turn radio and alarm on and off
14
Alarm track button: to select your favourite cd track for
ALT
waking up to music
Setting the clock time
1
While holding down the TIME button (10), press the
desired time. The PM indicator will light up when 12:00 midday is reached.
2
Release the button to save time setting.
Radio operation
FM wire aerial
To obtain the maximum FM reception fully extend the wire FM aerial (29) (which
is located at the rear of the unit) and alter the direction of the wire for best
results.
The aerial for the MW waveband is located inside the unit. To obtain the
maximum MW reception rotate the clock radio.
1
Slide the FUNCTION SELECTOR switch (15) to select MW or FM.
2
Press the POWER on/off button (13).
3
Adjust the VOLUME control (16) to a suitable level.
4
Slowly adjust the TUNING control (24) to select your desired station. The
FM LED indicator (23) will light up when an FM stereo signal is received.
5
To switch off the radio, press the POWER on/off button (13).
To play compact disc
1
Press the power on/off button.
2
Open the cd door and load a disc in the cd compartment (18).
3
Select the cd mode (15).
4
Press the
button (1). The display will show the track number when you
begin to play a cd. After a few seconds, the display reverts to the current
time.
Note : The same button can be used to momentarily interrupt playback. The
track number will flash until the
5
Adjust the volume control (16) until the desired level is reached.
6
Press the
button (2) to stop playback.
7
To switch off the cd, press the power on/off button.
28
29
4 5 6 7 8
9
10 1 1 12 1314
19
AL1
AL2
FM Stereo
15
Function selector switch
CD/MW/FM stereo
16
Volume control
forward):
17
Headphone jack 3.5mm
18
cd compartment
19
Clock display
20
Alarm 1 + 2 switch
21
Alarm 1 and 2 LED
indicators
22
Alarm selector
23
FM stereo LED indicator
24
Tuning control: to select
a radio station
25
Scale and pointer
26
Speakers
27
Power cord
28
Battery compartment
29
FM wire antenna
30
ALT LED indicator
31
Power LED indicator
P.2
or
(3) to set the
button (1) is pressed again.
P.4
26
30
31
20
21
22
23
24
25

Advertisement

loading

Summary of Contents for Morphy Richards 29003

  • Page 1: Operating Instructions

    29003 OPERATING INSTRUCTIONS Electrical requirements Check the voltage on the rating plate of your clock radio corresponds with your house electricity supply which must be A.C. (Alternating current). For cd clock radios with a fitted plug. If the socket outlets in your home are not suitable for the plug supplied with this appliance the plug should be removed and the appropriate one fitted.
  • Page 2 Guarantee Morphy Richards products are manufactured to internationally accepted quality standards. In addition to your statutory rights, Morphy Richards guarantee your product to be free from manufacturing and component defects for a period of TWO YEARS from date of purchase.

This manual is also suitable for:

Ib29003