Using The Projector - Dell 2200MP User Manual

USING THE PROJECTOR

1. Control Panel
a. Source: Press
Component-I, S-video, and Analog YpbPr sources when
multiple sources are connected to the projector.
b. Resync: Press
source. Resync will not operate if the On-Screen Display is
displayed.
c. Menu: Press
and the Menu button to navigate through the OSD.
d. Four Directional keys: The four directional keys can be used to toggle through the
tabs in the OSD.
e. Keystone: Press either of the
the projector.
2. Remote Control
a. Power: See installing the projector, step 1 and 8, as well as Powering off you
projector (later in this section)
b. Press the Source button to step through Analog, RGB, Composite, Component-I, S-
video, and Analog YpbPr sources when multiple sources are connected to the
projector.
c. Resync: Press
operate if the On-Screen Display is displayed.
d. Directional keys: Use the up and down arrows to select OSD (On screen display)
items, use "left" and "right" button to make adjustments.
e. Hide: Press the Hide button to hide the image, press again to resume display of the
image. (Video mute).
f. Video Mode: The Dell 2200MP Microprojector has preset configurations that are
optimized for displaying data (PC Graphics) or video (movies, games, etc.). Press
Video Mode button to toggle between PC mode, Movie mode, sRGB, or User mode
(for user to setup and save preferred settings). Pressing the Video Mode button
once will show the current display mode. Pressing the Video Mode button again will
switch between modes.
g. Previous Page: Press the Previous Page button to page up. (USB must be
connected for this feature)
Y/AC/Staff/Documentation/ProjectorGuideShort 11/05 cc
to step through Analog, RGB, Composite,
to synchronize the projector to the input
to activate the OSD (On-screen display). Use the directional keys
buttons to adjust image distortion caused by tilting
to synchronize the projector to the input source. Resync will not
3