Operations And Specifications - Pioneer CDX-P1250 Service Manual

CDX-P1250

8. OPERATIONS AND SPECIFICATIONS

8.1 OPERATION
Clear button
8.2 SPECIFICATIONS
General
System ..................................................... Compact disc audio system
Usable discs .................................................................... Compact Disc
Signal format ....................................... Sampling frequency: 44.1 kHz
Power source ......................................................................... 14.4 V DC
Max. current consumption ........................................................... 1.0 A
Weight ............................................................................ 2.2 kg (4.9 lbs.)
Dimensions .......................................... 257 (W) × 94 (H) × 172 (D) mm
Audio
Frequency characteristics ................................ 5 — 20,000 Hz (± 1 dB)
Signal-to-noise ratio ............................ 92 dB (1 kHz) (IHF-A Network)
Distortion ................................................................................... 0.005 %
Dynamic range ................................................................. 90 dB (1 kHz)
Output level ...................................................... 1,000 mV (1 kHz, 0 dB)
Number of channels .............................................................. 2 (stereo)
Note:
Specifications and design are subject to possible modification with-
out prior notice due to improvements.
Number of quantization bits: 16; linear
(10.8 — 15.1 V allowable)
[10-1/8 (W) × 3-11/16(H) × 6-3/4 (D) in.]
If the power does not switch on or if the compact disc player does
not operate when the button on the multi-CD controller is pressed,
or if the multi-CD controller display is incorrect, press this button on
the player with the tip of a pencil to restore normal operation. (This
button is located inside the door.) Always press the clear button on
the multi-CD controller, too, after pressing this button.
• If the clear button is pressed when the player contains a magazine
or the ignition switch is set to the ON or ACC position, the CD title
display and ITS memory are cleared.