Before First Use - AEG DC4013001 User Manual

3.2 Accessories
• Wire shelf
For cookware, cake tins, roasts.
• Grill- / Roasting pan
To bake and roast or as pan to collect
fat.
• Trivet

4. BEFORE FIRST USE

WARNING!
Refer to Safety chapters.
4.1 Initial Cleaning
Remove all accessories and removable
shelf supports from the appliance.
Refer to "Care and
cleaning" chapter.
Clean the appliance before first use.
Put the accessories and the removable
shelf supports back to their initial
position.
4.2 Setting the time
You must set the time before you
operate the oven.
Only the top oven works
without the set time.
The indicator for the Time of day
function flashes when you connect the
appliance to the electrical supply, when
there was a power cut or when the timer
is not set.
Press the
correct time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
4.3 Changing the time
You cannot change the time
of day if the Duration
End
or button to set the
function operates.
For roasting and grilling.
Use the trivet only with
the Grill- / roasting pan.
• Telescopic runners
For shelves and trays.
Press
indicator for the Time of Day function
flashes.
To set a new time, refer to "Setting the
time".
4.4 Preheating
Preheat the empty appliance to burn off
the remaining grease.
Preheat the two ovens. Heat
up one oven at a time.
Set the functions listed
below, if applicable.
1. Set the function
temperature to 250ºC.
Let the appliance operate for 1 hour.
2. Set the function
temperature to 250ºC.
Let the appliance operate for 15
minutes.
3. Set the function
temperature to 250ºC.
Let the appliance operate for 15
minutes.
Accessories can become hotter than
usual. The appliance can emit an odour
and smoke. This is normal. Make sure
that the airflow is sufficient.
or
ENGLISH
again and again until the
and the
and the
and the
7