Location of controls
SOURCE
MODE
RELEASE
SEL
ATT
Refer to the pages listed for details.
1 SOURCE (Radio/CD/MD) button
2 MODE button
During radio reception:
Band select
During CD/MD playback:
CD/MD unit select
3 Volume +/– button
4 Z (eject) button
5 Display window
6 m/M (fast winding)/DIR (tape
transport direction change) buttons
7 SEEK button
Seek
Automatic Music Sensor
Manual search
8 DSPL (display mode change) button
9 EQ3 button
0 RELEASE (front panel release) button
qa SEL (select) button
qs RESET button (located on the front side
of the unit behind the front panel)
qd ATT (attenuate) button
SECTION 1
GENERAL
DISC
REP
SHUF
ATA
1
2
3
4
5
6
BTM
XR-CA360X/CA360
qf Number buttons
During radio reception:
Preset number select
During CD/MD playback:
(1) DISC –
(2) DISC +
(3) REP
(4) SHUF
qg Frequency select switch (E model)
(located on the bottom of the unit)
See "Frequency select switch" in the
Installation/Connections manual.
qh BTM/ATA button
qj SENS button
qk OFF button*
* Warning when installing in a car
without ACC (accessory) position on
the ignition key switch
Be sure to press (OFF) on the unit for 2
seconds to turn off the clock display after
turning off the engine.
When you press (OFF) momentarily, the
clock display does not turn off and this
causes battery wear.
Setting the clock
The clock uses a 12-hour digital indication.
Example: To set the clock to 10:08
1
DIR
EQ3
SEEK
DSPL
SENS
OFF
2
XR-CA360/CA360X
This section is extracted from
instruction manual.
Press (DSPL) for 2 seconds.
The hour indication flashes.
1 Press either side of the volume button
to set the hour.
to go forward
to go back
2 Press (SEL).
The minute indication flashes.
3 Press either side of the volume button
to set the minute.
to go forward
to go back
Press (DSPL).
The clock starts.
After the clock setting is complete, the
display returns to normal play mode.
3