Table of Contents
Advertisement
Available languages
Available languages
3 Install the car
entertainment
system
Always follow the instructions in this chapter in
sequence.
These instructions are for a typical installation.
However, if your car has different requirements,
make the adjustment accordingly. If you have
any question regarding installation kits, consult
your local retailer.
Note
•
This system is designed for negative ground (earth) 12V
DC operation only.
•
Always install this system in the car dashboard. Other
locations can be dangerous as the rear of the system
heats up during use.
•
To avoid short-circuit: before you connect, make sure
that the ignition is off.
•
Make sure that you connect the yellow and red power
supply leads after all other leads are connected.
•
Make sure that all loose leads are insulated with
electrical tape.
•
Make sure that the leads do not get caught under
screws iron parts that will move (e.g. seat rail).
•
Make sure that all ground (earth) leads are run to a
common ground (earth) point.
•
Use only the supplied mounting hardware for a safe
and secure installation.
•
Improper fuses can cause damage or fire. When you
need to change the fuse, consult a professional.
•
When you connect other devices to this system, make
sure that the rating of the car circuit is higher than the
total fuse value of all the connected devices.
•
Never connect speaker wires to the metal body or
chassis of the car.
•
Never connect speaker wires with stripes to one another.
Connect wires
Note
•
Make sure that all loose leads are insulated with
electrical tape.
•
Consult a professional to connect wires as instructed
below.
•
Before connection, check the car's wiring carefully.
EN
1
Connect the ISO male connectors.
ISO male
Connect to
connectors
a
Green strip,
Rear left speaker
black-edged
green strip
b
White strip,
Front left speaker
black-edged
white strip
c
Gray strip,
Front right speaker
black-edged
gray strip
d
Purple strip,
Rear right speaker
black-edged
purple strip
e
Red strip
Ignition key +12V DC
when ON/ACC
f
Blue strip
Motor/electric antenna
relay control lead
g
Black strip
Ground
h
Yellow strip
The +12V car battery
which is energized at all
times
2
Connect other wires if necessary.
Caution
•
To avoid an accident, the driver must not watch video
while driving. By design, this system disallows watching
video during drive. Park your car in a safe place and
engage the parking brake before watching video.
Page 6
- Quick Links:
- Smart Connect Link
Hide quick links:
Advertisement
Chapters
Table of Contents
