Table of Contents
Advertisement
0
RECALL/ENTER button
It is used for RECALL of stored programs in the
unit. (Refer to page 11)
!¡
DISPLAY button
Press the button to switch the display mode of
the unit. (Refer to page 9)
!™
UP button
!£
DOWN button
Use these buttons when you make the number
+/– to operate RECALL or change REMOTE ID
(For RECALL and changing REMOTE ID, refer
to page 11 and page 12, respectively.).
!¢
REMOTE terminal
For controlling the unit with an external com-
puter. It has D-Sub 9 pin male type connector
and RS-232C format. It is equal and has same
function with that in the rear panel. See "Com-
munication Protocol Guide" for more detail on
communication.
NOTE
Unit of level indicator
OVER:
Lights up when the wave reaches
digital's full scale (the clipping
level). You need to lower the level
when it lights up often.
–6, –10, –20, –40:
Indicates the level in decibels
(dBFS) based on digital full scale.
7
Hide quick links:
Advertisement
Table of Contents
