Parts Names And Functions - Sony SRP-F300 Operating Instructions Manual

2. PARTS NAMES AND FUNCTIONS

2-1. Front panel
ON OFF
3
2
1
Power Switch
To turn the power on/off. When the unit is
turned on, the previous signal setting is recalled.
2
Input channel indicator (Refer to
Indicates the peak input signal level. The selected
signal level is indicated. The indication is
updated every 100 msec and the indicated level
is the peak level in the previous 100 msec. When
generating a test signal, the level of the test signal
is indicated. (Use an external computer for
choosing input signal source).
3
Compressor indicator
Illuminates when gain reduction takes place in
the compressor of the input channel. The indica-
tor is updated every 100 msec. It does not light
up when compressor is not selected. (Use an
external computer to select and adjust the
compressor).
4
Output channel indicator (Refer to
Indicates signal levels after processing all signals
of each output. The indications correspond to the
level scale printed at the left side of the indica-
tors. The indication is updated every 100 msec
and the indicated level is the peak level in the
previous 100 msec. As it indicates the final
output signal level, it will not light up when the
output channel is muted.
6
1
INPUT
1 2 A B
COMP LIMITER IN-1 LIMITER IN-1 LIMITER
OVER OVER IN-2 OVER IN-2
-6 -6 HF -6 HF
-10 -10 MF -10 MF
-20 -20 LF -20 LF
-40 -40 8LF -40 8LF
1 2
COMP 5
LIMITER
OVER
-6
-10
-20 4
-40
NOTE
NOTE
7
OUTPUT
C D E F
IN-1 LIMITER IN-1 LIMITER IN-1 LIMITER IN-1 PROGRAM
OVER IN-2 OVER IN-2 OVER IN-2 OVER IN-2
OUTPUT STATUS
-6 HF -6 HF -6 HF -6 HF
REMOTE I/D
-10 MF -10 MF -10 MF -10 MF
-20 LF -20 LF -20 LF -20 LF
-40 8LF -40 8LF -40 8LF -40 8LF LOCK
8
IN-1
OVER IN-2
6
-6 HF
-10 MF
-20 LF
-40 8LF
5
Output channel peak limiter indicator
Illuminates when signal wave's peak reaches the
limites setting level and clip has occurred at each
output channel. The indication changes at every
100 msec. If it lights up often, adjust the output
)
level as signal distortion is possible. (Use an
external computer to adjust).
6
Output channel assignment indicator
Indicates the current assignment of output
channel. The indications corresponds to the print
at the right side of the indicators. (Refer to page
9).
7
DISPLAY mode indicator
Indicates the unit's display mode. (Refer to page
9).
8
LOCK indicator
When lit, it is impossible to use the buttons on
the front panel.
This case means the audio processor is controlled
)
by an external computer or it is locked by
external control.
9
Number Display
Displays the current program number or RE-
MOTE ID number. (Refer to page 9).
9 ! #
RECALL
UP
/ENTER
REMOTE
(RS-232C)
DISPLAY DOWN
DIGITAL AUDIO PROCESSOR SRP-F300
" $ %