When The Dvd Video Is Finished; Operating The Dvd Player - Sony SCPH-10173 Instruction Manual

Notes on the playback of DTS audio from a DVD video
DTS audio signal can only be output through an optical digital cable (sold
separately). Please note that it cannot be output through a regular audio
cable.
• Do not set the "DTS" option of "Audio Digital Out" under "Audio Setup"
to "On" when using an audio component that does not have a built-in
DTS decoder. In such cases, if the "DTS" option is set to "On", a loud
noise (or no noise) will come from the speakers, possibly hurting your
ears or damaging the speakers.
• When the "DTS" option of "Audio Digital Out" under "Audio Setup" is
set to "Off", the DVD's DTS audio output will not be played back, even if
you connect with an optical digital cable.
z When the DVD video is finished
1
Press the A button on the PlayStation
2
Remove the disc.
3
Press the A button.
Note: After changing DVD settings
To save your changes, be sure to eject the DVD before pressing the 1/RESET
button or turning off the console with the MAIN POWER switch. Please note that
changes will not be saved if you reset or turn off the console without first ejecting
the DVD.
z Operating the DVD Player
The DVD Player can be operated using the buttons of the DVD Remote
Control, the direct buttons of the Analog Controller (DUALSHOCK
from the onscreen Control Panel.
Notes
• Depending on the disc used, some operations may vary or may not be possible.
• The method of operation for certain functions may vary depending on whether the
IR receiver unit is inserted into the PlayStation
2 console.
®
2 console or not.
®
2) or
®
11