Loading Tracks And Playing Them - Pioneer DDJ-RX Operating Instructions Manual

Dj controller
Hide thumbs Also See for DDJ-RX:
Table of Contents

Advertisement

Adding music files to [Collection]
"Collection" is music files that are managed by rekordbox.
Music files on the computer can be used with rekordbox if they are analyzed and
registered as rekordbox music collection files.
1 Click [Collection] in the tree view.
The [Collection] music files are displayed in the track list.
2 Open Finder or WindowsExplorer and drag and drop music
files and/or folders, where music files are stored, to the track
list.
The music files are added to the collection, and the waveform information analysis
of the music files starts. Wait until the analysis of all the music files are finished.
a
Track list

Loading tracks and playing them

The following describes the procedure for loading tracks into deck [1] as an
example.
1 Rotary selector
2 BACK button
3 LOAD button
1 Press this unit's [BACK] button, move the cursor to the tree
view on the computer screen, then turn the rotary selector
and select a collection or playlist, etc.
2 Press the rotary selector, move the cursor to the track list
on the computer screen, then turn the rotary selector and
select a track.
b
b
a
Track list
b
Tree View
3 Press the [LOAD] button to load the selected track onto the
deck.
16
En
Playing tracks and outputting the sound
The following describes the procedure for outputting the channel 1 sound as an
example.
! Set the volume of the devices (power amplifier, powered speakers, etc.) con-
nected to the [MASTER OUT 1] and [MASTER OUT 2] terminals to an appropri-
ate level. Note that loud sound will be output if the volume is set too high.
a
a
4 TRIM control
5 EQ (HI, MID, LOW) controls
6 COLOR control
7 Headphones CUE button
8 Channel fader
9 Crossfader Assign Switch
a MASTER LEVEL control
b BOOTH MONITOR LEVEL control
c SOUND COLOR FX buttons
d MASTER CUE button
e Crossfader
f HEADPHONES LEVEL control
a
a
g HEADPHONES MIX control
h INPUT SELECT switch
i CROSS FADER CURVE control
1 Set the positions of the controls, etc., as shown below.
Names of controls, etc.
MASTER LEVEL control
TRIM control
EQ (HI, MID, LOW) controls
COLOR control
Channel fader
Crossfader Assign Switch
INPUT SELECT switch
4
a
5
b
c
6
7
d
8
9
f
g
h
e
i
Position
Turned fully counterclockwise
Turned fully counterclockwise
Center
Center
Moved forward
[THRU] position
[PC] position

Advertisement

Table of Contents
loading

Table of Contents