Tower installation
Shipping bracket kit
If you are shipping the UPS and its associated EBMs preinstalled in a rack, you
must use the shipping bracket kit to prevent damage during shipment. The kit is
available from Lenovo. Refer to the instructions in the kit to install the brackets
properly. The brackets are not required when the UPS and EBMs are installed in a
pre-positioned rack.
Rear panels
Figure 1. 5594-8KX, 5594-8PX
Figure 2. 5594-9KX, 5594-9PX
6
Installation and User's Guide
RS232 communication port
USB communication port
Dry (relay) contacts communication
port
Connector for Remote On/Off
(ROO) control
Connectors for automatic recognition
of battery module
Connector for Remote Power Off
(RPO) control
Slot where UPS Network
Management Card is installed
Connector for battery module power
Terminal blocks for AC power input
and output
Connector for HotSwap MBP
detection