Table of Contents
Advertisement
CAUTION:
v Do not install a unit in a rack where the internal rack ambient temperatures
v Do not install a unit in a rack where the air flow is compromised. Ensure that
v Consideration should be given to the connection of the equipment to the
v (For sliding drawers) Do not pull out or install any drawer or feature if the rack
v (For fixed drawers) This drawer is a fixed drawer and must not be moved for
(R001 part 2 of 2)
Output power and ampere ratings
Important: Make sure that the power receptacle is near the equipment and is
easily accessible so that the uninterruptible power supply (UPS) can be
disconnected quickly.
To reduce the risk of fire, connect only to a circuit provided with branch circuit
overcurrent protection with an ampere rating in accordance with the National
Electrical Code (NEC), ANSI/NFPA 70 or your local electrical code:
Product safety
v The UPS connection instructions and operations described in the manual must
v
xiv
Installation and User's Guide
will exceed the manufacturer's recommended ambient temperature for all your
rack-mounted devices.
air flow is not blocked or reduced on any side, front, or back of a unit used
for air flow through the unit.
supply circuit so that overloading of the circuits does not compromise the
supply wiring or overcurrent protection. To provide the correct power
connection to a rack, refer to the rating labels located on the equipment in the
rack to determine the total power requirement of the supply circuit.
stabilizer brackets are not attached to the rack. Do not pull out more than one
drawer at a time. The rack might become unstable if you pull out more than
one drawer at a time.
servicing unless specified by the manufacturer. Attempting to move the
drawer partially or completely out of the rack might cause the rack to become
unstable or cause the drawer to fall out of the rack.
UPS output power
120 V
1500 VA
15 A
2200 VA
20 A
3000 VA
30 A
be followed in the indicated order.
Important: To reduce the risk of fire, the unit connects only to a circuit provided
with branch circuit overcurrent protection as described in this manual, in
accordance with the National Electric Code, ANSI/NFPA 70.
208 V
230 V
Not applicable
10 A
Not applicable
10 A
20 A
16 A
Advertisement
Table of Contents
