Working Advice; Troubleshooting - Bosch AHS 45-15 LI Original Instructions Manual

Hide thumbs Also See for AHS 45-15 LI:
Table of Contents

Advertisement

OBJ_BUCH-1809-004.book Page 8 Thursday, September 24, 2015 8:39 AM
8 | English
Charging Advice
With continuous or several repetitive charging cycles without
interruption, the charger can warm up. This is not meaningful
and does not indicate a technical defect of the battery charg-
er.
A significantly reduced working period after charging indi-
cates that the battery is used and must be replaced.

Working Advice

 Hold the garden product away from yourself. Stand in a
secure and stable position.
 When storing the product, do no store it hanging on the
front handle or switch.

Troubleshooting

Problem
Possible Cause
Hedgecutter does not
Battery discharged
operate
Safety switch not activated correctly
Hedgecutter operates
Internal wiring of machine damaged
intermittently
On/Off switch defective
Motor reverses repeatedly then stops after 3 s. see "Working Advice" (Anti Blocking)
Motor runs but blades
Internal fault
remain stationary
Cutting blade hot
Cutting blade blunt
Cutting blade has dents
Too much friction, due to lack of lubricant
Blade will not move
Battery discharged
Machine defective
Excessive vibra-
Machine defective
tions/noise
Cutting time per battery
Too much friction, due to lack of lubricant
charge too low
Blade needs cleaning
Battery not fully charged
Continuous lighting of the
Battery not (properly) inserted
battery charge indicator
Battery contacts contaminated
No charging procedure
possible
Battery pack defective
F 016 L81 270 | (24.9.15)
Anti Blocking
If the blade stalls on a tough material, the load of the motor in-
creases. The intelligent micro-electronics senses this over-
load condition and repeatedly reverses the motor, in order to
prevent stalling and to cut the material through.
This audible reversing cut action continues for up to 3 s.
After cutting through, the garden product continues in its nor-
mal mode, or in case the overload condition continues the
blades automatically stop in the open position (e. g. in case a
piece of metal fence accidentally blocks the garden product).
Corrective Action
Recharge battery; also see "Battery Charging"
see "Mounting and Operation" for correct use
Contact Service Agent
Contact Service Agent
Contact Service Agent
Have blade sharpened
Have blade inspected/overhauled
Apply lubricant spray (1 609 200 399)
Recharge battery; also see "Battery Charging"
Contact Service Agent
Contact Service Agent
Apply lubricant spray
Clean blade
Recharge battery; also see "Battery Charging"
Properly insert battery into battery charger
Clean the battery contacts (e.g. by inserting
and removing the battery several times) or re-
place the battery
Replace the battery
Bosch Power Tools

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ahs 350 liAhs 35-15 li

Table of Contents