Sony CDP-CX260 Service Manual page 27

THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
• ¢ : internal component.
• C : panel designation.
Note: Note:
The components identi- Les composants identifiés par
une marque ! sont critiques
fied by mark ! or dotted
pour la sécurité.
line with mark ! are criti-
Ne les remplacer que par une
cal for safety.
piéce por tant le numéro
Replace only with part
spécifié.
number specified.
• U : B+ Line.
• V : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : STOP
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
J
: CD
c : digital out
For printed wiring boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• ®
: Through hole.
• b : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B) pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A) parts face are indicated.
• Indication of transistor
C
Q
These are omitted
B E
B C E
These are omitted
– 29 –
WAVEFORMS
1
3.1Vp-p
16.9MHz
IC101 ^§ XTAI
2
1.2Vp-p
(PLAY)
IC101 %¡ RF AC
3
2.5V
APPROX 500mVp-p (PLAY)
IC101 $¡ TE
4
2.5V
APPROX 200m Vp-p (PLAY)
IC101 #ª FE
5
2.4Vp-p
7.5µsec
IC101 @§ MDP
6
3.8Vp-p
10MHz
IC501 #¡ EXTAL
– 30 –