Honeywell PM42 User Manual page 62

Chapter 5 — Troubleshoot the Printer
54
Maintenance and Error Alerts (continued)
Alert
Odometer (User
Resettable)
Printhead Too Hot
Printhead Not
Detected
Faulty Dot
Replace Printhead The printer has reached a limit set in the Replace
Clean Printhead
Upgrading
Firmware
Printer is
Rebooting
Started
Motor Too Hot
Solution
The printer has reached a limit set in the Odometer
(User Resettable) setting in Maintenance Alerts for
the amount of media printed since the last reset.
The printhead is overheated and needs to cool
down. Wait for printing to resume automatically.
The printer is not detecting the printhead. Check to
make sure the printhead is installed and that the
printhead cable is firmly connected to the
printhead.
The printhead has reached the number of faulty
dots set in the Faulty Dots setting in Maintenance
Alerts. You may need to replace the printhead.
Printhead setting in Maintenance Alerts for the
amount of media to print before replacing the
printhead. Replace the printhead.
The printer has reached a limit set in the Clean
Printhead setting in Maintenance Alerts for the
amount of media to print before cleaning the
printhead. Clean the printhead.
The printer is going to start upgrading the
firmware. Do not try to send anything to the printer.
The printer is going to restart. Wait until the printer
is ready before attempting to communicate with it.
The printer is in the process of starting up.
The printer motor has reached its maximum
operating temperature limit. Let the motor cool
down before you resume printing.
PM42 Mid-Range Printer User Manual