Subscribe to Our Youtube Channel
Related Manuals for Moffat TURBOFAN P12M Series
Summary of Contents for Moffat TURBOFAN P12M Series
- Page 1 PSERIES P 8 M / P 1 2 M S e r i e s P r o o f e r / H o l d i n g C a b i n e t s ( M a n u a l O p e r a t i o n ) I n s t a l l a t i o n a n d O p e r a t i o n M a n u a l 234277-2...
- Page 2 The reproduction or copying of any part of this manual by any means whatsoever is strictly forbidden unless authorized previously in writing by the manufacturer. In line with policy to continually develop and improve its products, Moffat Ltd. reserves the right to change the specifications and design without prior notice.
-
Page 3: Table Of Contents
P8M / P12M Turbofan Proofer / Holding Cabinets. Model Numbers Covered in this Manual - Turbofan Proofer / Holding Cabinet P12M - Turbofan Proofer / Holding Cabinet Introduction ... 2 Safety Information Specifications ... 3 Installation... 4 Installation Requirements Unpacking Location Clearances Electrical Connection... -
Page 4: Introduction
Before using your new Proofer / Holding Cabinet, please read this instruction manual carefully, pay particular attention to any information labelled ‘WARNING’, ‘CAUTION’, ‘IMPORTANT’ or ‘NOTE’ in this manual. Indicates a hazardous situation Warning which, if not avoided, will result in death or serious injury. -
Page 5: Specifications
P8M Proofer / Holding Cabinet P8M / P12M Specifications Tables:- Power Ratings 110-120V, 1P+N+E, 220-240V, 1P+N+E, 110-120V, 1P+N+E, P12M 220-240V, 1P+N+E, Specifications P12M Proofer / Holding Cabinet Tray Capacity 60HZ, 1.45 kW 8 x US Full Pan 8 x EN 600 x 400 mm tray 50/60HZ, 1.50 kW 60HZ, 1.95 kW 12 x US Full Pan... -
Page 6: Installation
. Ensure that the appliance is fitted with the appropriate power cord and plug. Proofer / Holding Cabinet Serial Number Proofer / Holding Cabinet Model Number Current Draw MOFFAT LIMITED MODEL CHRISTCHURCH ( NEW ZEALAND ) USP8M CODE xxxxxx SERIAL... -
Page 7: Water Connection
Water Connection 1. A cold water supply should be connected to the water inlet located on the rear right hand side of the unit. 2. A connection elbow and sealing washer are supplied with this unit for direct connection of a ¾” ID hose, and is recommended for easy installation and service. -
Page 8: Operation
Operation Guide • Turbofan Proofer / Holding Cabinets have been designed to provide simple operation. • This Proofer / Holding Cabinet was intended, i.e. proofing and holding of food products. the following sections carefully:- Proofer / Holding Cabinet Control Panel Control Panel (˚F) Control Panel (˚C) Operation... -
Page 9: Operating In 'Proof' Mode
Operating in ‘Proof’ Mode Caution Take care when opening holding cabinet door during the Proofing Mode. Let hot air and steam escape before removing or replacing food as the steam produced can cause steam burns. Ensure that power to the proofer / holding cabinet is switched ‘On’... -
Page 10: Cleaning
Cleaning Guidelines Caution Always turn ‘Off’ the electrical power supply mains supply before cleaning. This proofer / holding cabinet is not water proof. Do not use water jet spray to clean interior or exterior of the appliance. To achieve the best results, cleaning must be regular and thorough. - Page 11 e. Dry the racks thoroughly with a dry cloth and polish with a soft dry cloth. f. To refit the racks, engage the front and rear upper rack keyholes onto the upper hanger studs. g. Raise the rack up again slightly until the lower rack keyholes engage onto the lower studs, ensuring that the upper studs remain engaged.
- Page 12 Lamp Glass The P8 and P12 proofer / holding cabinets are fitted with 2 halogen lamps. These are fitted on the L/H inner side panel, behind the L/Hand side rack. Interior Lamps a. To remove lamp glass, ensure that the L/Hand side rack is removed as shown on the prevous page.
-
Page 13: Fault Finding
This section provides a reference to the more common problems that may occur during the operation of your proofer / holding cabinet. This fault finding guide is intended to help you correct, or at least accurately diagnose problems with your proofer / holding cabinet. When fault finding a problem, always use a process of elimination starting with the simplest solution and working through to the most complex. -
Page 14: Electrical Schematic
Electrical Schematic Electrical Schematic P8M - P12M Proofer Holding Cabinets. -
Page 15: Replacement Parts List
Replacement Parts List Only genuine authorized replacement parts should be used for the servicing and repair of this proofer / holding cabinet. The instructions supplied with the parts should be followed when replacing components. For further information and servicing instructions, contact your nearest authorized service provider or Turbofan Dealer. When ordering replacement parts, please quote the part number and the description as listed below.
Need help?
Do you have a question about the TURBOFAN P12M Series and is the answer not in the manual?
Questions and answers