2
Insert (remove) the microSD card into (from) the card slot.
≥ Insert the microSD card with its terminal side facing down. Push it straight in until it clicks into
place as shown in the figure.
≥ Press the centre of the microSD card and then pull it straight out.
3
Rotate the terminal cover in the opposite direction of Step 1 to attach it.
≥ Tighten it firmly to ensure that it is not loose.
Preparation
Turning this unit on/off
Press the power button to turn on this unit.
The power lamp is turned on.
About overheat detection
If the internal temperature of this unit rises during use, warning beeps will be heard and the power
lamp will flash fast. This unit will then turn off automatically. To use this unit again, wait until it cools
down.
≥ This unit cannot be used until it cools down.
About battery level indications
You can check the battery level by looking at the recording mode lamps when you have turned on
this unit.
Battery level
Recording mode lamps
≥ The battery level can be checked for a few seconds after this unit has been turned on.
16
SQT0886 (ENG)
To turn off this unit
Press and hold the power button for
approximately 1 second.
≥ The power lamp goes off after a while.
100% to 76%
75% to 41%
40% to 21%
20% or less