Haier DW12-BFE Service Manual page 7

Serial Number: 0120502282 Version:00.00 Bom:FA01P0E0300 Edition: 2005-7
Dishwasher
Model: DW12-BFE/SS/ME
If the water pipes are new or have not been used for an extended period of time, let the water run to make
sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the water
inlet can get blocked and damage the appliance.
5.4 Hot Water Connection
The water supply to the appliance can also be connected to the
house's hot water line (centralised system, heating system), as long as it does not exceed a temperature of 60
℃ . In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency slightly
reduced.
5.5 Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm,or let it run into the sink, making sure
to avoid bending or crimping it. Use the special plastic support that comes with the appliance (see Fig.2). The
free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water.
5.6 Anti-Flooding Protection
The dishwasher is equipped with a system that stops the supply of water in the event of a problem with the
water supply hose, or leaks within the unit, in order to prevent damage to your home. If for any reason the box
containing the electrical components happens to get damaged, remove the plug of the appliance from the
socket immediately. In order to guarantee that the anti-flooding feature operates properly, the box "A" with the
water supply hose must be attached to the water supply tap as shown in Fig.1. No other type of connection is
acceptable. The water supply hose must not, under any circumstances, be cut, as it contains electrical parts
which are live. If the length of the hose is not adequate to make a proper connection, the hose must be
replaced with one which is long enough. This hose is available upon request from specialized retailers and
service centres.
5.7 Electrical Connection
After making sure that the voltage and frequency values for the current in the home correspond to those on
the rating plate (located on the stainless steel inner door of the appliance) and that the electrical system is
correct for the maximum voltage on the rating plate, insert the plug into an electrical socket which is earthed
properly (the earthing of the appliance is a safety requirement mandated by law). If the electrical socket to
Page 7 / 21