Glass Cooktop; Porcelain Cooktop - GE JGP636 Installation Instructions Manual
Hide thumbs
Also See for JGP636:
- Installation instructions manual (33 pages) ,
- Owner's manual (32 pages) ,
- Owner's manual (16 pages)
Table of Contents
Advertisement
B. Remove the valve control knobs.
C. Through
the openings, locate the valve bypass
screws located on the lower right side of the
valves.
D.
Using a screwdriver,
screw down fully, in a
clockwise rotation, the brass bypass screw.
E. Using a 7mm or 9/32” nut driver, remove the top
burner orifices.
These may be accessed through
the burner air/gas mixer tube (chimney).
MIXER TUBE (CHIMNEY)
NOTE:
The ofilces
have a spring loaded
retaining
ring around the hex head to hold the ori~lce
in the nut driver
during installation
and
removal.
A slight amount
of force is
required
to push the nut driver
down over
the ring.
!3
RETAINER
RING
SPECIAL
NOTE:
To convert
the range back to
natural gas, use the orifices
that
you removed
during the L.P./
Propane
conversion
and reverse
steps 1-6 of the L. P./ Propane
conversion
section.
5.
Locate the L.P. /Propane orifices
The L.P. /Propane oritlces are shipped in the
literature package.
They will have a digit number
and the letter “L” on one side.
Each orifice will also show a series of engraved
marks, (I, 11or III), located on the top.
00(2
These marks denote the precise location of each
orifice to the cooktop burner.
GLASS COOKTOP
6. Install the L. P./Propane
orifices in their precise
locations.
PORCELAIN
COOKTOP
Adjust the low [lame setting using the valve bypass
scre’,v as follows:
Lo\v setting adjustments
must be made with t~vo
other burners in operation on a medium setting.
This procedure pre~rents the low flame from being
se[ too low resulting in the flame belnq extinguished
~vhen other burners are turnecl on.
Advertisement
Table of Contents
