GE 12 Owner's Manual And Installation Instructions page 10

REVERSING THE DOOR SWING
3
MOVE THE BOTTOM HINGE
Remove the bottom hinge.
Move the plug buttons from the opposite side to the
holes left vacant by the hinge.
Remove the bottom hinge pin along with the washer
and put them on the other side of the hinge.
Attach the bottom hinge on the other side.
Bottom hinge
4
REHANG THE FRESH FOOD DOOR
Slide the bottom socket of the fresh food door onto
the bottom hinge pin and close the door.
Slide the hinge pin into the top socket of the fresh food
door on the opposite side of its original location and
reinstall the hinge. Make sure washers are in place.
NOTE: The center hinge must be turned over as
shown when mounted on the opposite side.
Washers
Center hinge
10
Installation Instructions
Washer
Hinge pin
Bottom hinge
(CONT.)
5
REHANG THE FREEZER DOOR
Lower the bottom socket of the freezer door onto the
center hinge pin and close the door.
Fit the top pin into the socket at the top of the freezer
door, making sure that the washer is in place on the
underside of the top hinge. Tighten the screws and
replace the hinge cover.
Top hinge
6
MOVE THE VACUUM BREAK
(on some models)
2"
Vacuum
break
The vacuum break makes the door easier to open
(Part No. WR02X8905). Carefully peel it from its
original location and install it on the other side.
Apply it to the flat metal surface at the top front of
the refrigerator case. It should be about 2" from the
edge on the hinge side of the refrigerator.
Top Hinge Cover
2"
Vacuum
break